- #Cisco ios command activate right to use license on device how to
- #Cisco ios command activate right to use license on device software
- #Cisco ios command activate right to use license on device series
#Cisco ios command activate right to use license on device software
For the latest feature information and caveats, see the release notes for your platform and software release. Go check your Smart License portal and you will notice new licenses in a pool assigned to added devices.Configuring Cisco Right-To-Use License First Published: July 2012įinding Feature Information Your software release may not support all the features documented in this module. Status: Successful on Oct 29 09:33:31 2019 UTCĪs you can see, license is AUTHORIZED (i.e. Next Communication Attempt: Nov 28 09:33:33 2019 UTCĬommunication Deadline: Jan 27 09:28:32 2020 UTC
Last Communication Attempt: SUCCEEDED on Oct 29 09:33:34 2019 UTC Initial Registration: SUCCEEDED on Oct 28 23:12:38 2019 UTC Smart Licensing hostname privacy: DISABLED Once device is registered, execute RTU to Smart License conversion as shown above, then check your license again and it must be compliant: Smart Licensing is ENABLED Keep in mind, will have to be generated via Smart License portal to make sure device is added to correct Virtual Account (VA). I assume you’ve already setup Smart License Account, there will only show a minimum required config: Switch(config)#call-home Make sure you enable Smart License before you perform the conversion. It is the following license smart conversion start
#Cisco ios command activate right to use license on device how to
So, one might be guessing how to remain compliant?Īpparently, there’s a very handy command that performs the conversion of RTU license into Smart License. In fact, we haven’t even had any PAK codes, it was all RTU based. I was confused initially as all our Catalyst 3850 switches have been purchased using Cisco One license, well before Smart License become mandatory. So, keep this in mind and plan carefully.
It won’t affect basic switch functions, but will definitely affect anything DNA-based (e.g. When you upgrade, switches will silently activate EVALUATION mode, which will be valid for the next 90 days, but then, if you do not configure Smart Licensing you automatically go into non-compliance state.
#Cisco ios command activate right to use license on device series
Release Notes for Cisco Catalyst 3850 Series Switches, Cisco IOS XE Fuji 16.9.x Starting from Cisco IOS XE Fuji 16.9.1 the Right-To-Use (RTU) licensing mode is deprecated, and the associated license right-to-use command is no longer available on the CLI. Cisco made this licensing mandatory for Catalyst switching platforms starting from Fuji 16.9.1, as per below However, it also brings some challenges and surprises that everyone must be aware of.įirst of all, keep in mind that eventually everything will be Smart License managed. Overall, this new system brings loads of benefits, such as ability to track license utilization, see all managed instances by hostname, transfer licenses and product instances between virtual accounts (i.e. It’s been a while since Cisco has announced Smart License to replace Traditional PAK-based licensing.
0 kommentar(er)
